Installation Instructions
Step 1
Clean pipe surface thoroughly, particularly in area where gasket will seat.
Step 2
Check gasket for proper positioning in saddle body.
Step 3
Lubricate pipe and face of gasket with a suitable lubricant.
Step 4
Mount saddle body (with gasket in place) on pipe.
Step 5
Install saddle strap(s), nuts and washer(s).
Step 6
Prior to tightening, position saddle as required to suit installation.
Step 7
Tighten nuts progressively and uniformly (40 ft. lbs. maximum recommended torque).
Do Not Over Torque! Over torquing will not increase sealing ability and may cause failure in the pipe or
saddle.
Caution: Bolt length A and B must be kept equal.
Step 8
Make connection to saddle boss. Suitable pipe thread sealant is recommended. Do not cross thread.
Note: Use of this product on plastic pipe is limited to:
2. 4.80 - 21.60 Cast Iron O.D. C-900 PVC Pipe Class 150 rating or better (DR18).