机械表就像人一样如果长时间的闲置活着是无所事事，机械表的发条自然放松至表款静止不动如果您要重新佩带，就必须重新上紧发条、校准时间等相应的繁琐事项。一般的机械表在发条**松的时候，会出现时针、分针变慢或变快的现象，所以，应该先上紧发条，以免校准时间后，没有标准动力驱动指针，即使是自动上炼表款，也应先用手动上炼至八分满，再进行时间校准。

　　机械表自行清洗以及保养的原则：

　　凡是从事过水上活动的表款，都需要做保养的，尤其经过海水盐分的浸泡，游泳池内过滤水质的化学物品，都容易造成表款防水垫圈的侵蚀、硬化有些保养是可以自己在家做的，简单的以软布用少量肥皂水清洗金属及防水橡胶表带，**后并以湿布清除肥皂水擦拭过的痕迹后阴干，就可以达成初步保养的性能，同时，千万不要将表直接送到有超音波设备的地方做清洗，因为超音波的清洗有分强、弱不同频率，一但使用不对的超音波频率，就容易造成内部零件松脱。

　　机械表自行清洗、保养的原则： (1) 软布沾肥皂水擦拭 (2) 软布沾清水擦拭 　(3) 干软布擦拭 (4) 阴干(5) 忌讳不随便送超音波清洗

　　长时间的使用或长时间的收纳表款，必须特别留意表款的保养期限，一般机械表款的保养期限约3~4年，一旦超过这个期限，表壳内部润滑油容易干渍，外部的防水垫圈则容易硬化，勉强使用容易发生机械零件故障与进水以及润滑油干渍导致零件磨损的问题，初期还不致影响运转，只会看到时间的精准度越来越低，久而久之，当停止运转时，内部零件的损耗已经非常严重，到了这样的地步，「微少」的保养费用就变成「大笔」的零件维修费用支出。

　　mechanical watches like people alive if long time idle is idle, the mechanical watch spring relaxed to watch motionless if you want to re wear, must be rewound, calibration time of the corresponding complicated matters. The general mechanical table when a very loose, there will be an hour hand and a minute hand slow or fast phenomenon, therefore, should be a wound, so as to avoid the calibration time, there is no standard driving pointer, even the automatic mixing table, it should use manual mixing to eight points over again time calibration.

　　mechanical table to clean and maintain the principle:

　　all engaged in water sports watches, all you need to do maintenance, especially after seawater salt immersion, chemicals in the pool of water filtration, are likely to cause erosion, hardening watch waterproof washer some maintenance can make at home, simple with a soft cloth with a small amount of soap and water cleaning waterproof rubber and metal watchband, and finally to remove wet soapy water wipe traces after dried, performance can reach preliminary maintenance at the same time, do not be sent directly to a table of ultrasound equipment, local cleaning, ultrasonic cleaning because of strong and weak points with different frequencies, but not the use of a supersonic frequency and it is easy to cause the internal parts loose.

　　Table

　　mechanical self cleaning and maintenance principles: (1) a soft cloth dipped in soapy water wipe (2) with soft cloth to clean water (3) dry soft cloth (4) shade (5) taboo not just send ultrasonic cleaning

　　The use of

　　for a long time or long time storage table, must pay special attention to watch the maintenance period, the general mechanical watches the maintenance period of about 3~4 years, once over this period, the case of internal lubricating oil is easy to dry stains, external waterproof gasket is easy to harden, reluctant to use volume mechanical parts failure occurs easily with water the lubricating oil and dry stains cause wear problems, early also does not affect the operation, will only see the accuracy of time become increasingly low, in the course of time, when to stop running, the internal parts of the loss is very serious, to the point of "small" maintenance costs become "big" parts repair expenses.